The challenges of size in plants - OCR GatewayDistribution of stomata and guard cells

Counting stomata

Scientists use sampling and counting techniques to investigate the distribution of stomata on leaves. They count stomata to investigate:

• their numbers, density and distribution on upper and lower surfaces
• numbers that are open and closed at any time
• adaptations of plants to environmental conditions, eg desert and water plants
• effects of changing conditions such as increased carbon dioxide concentrations from climate change

Below are two methods with which stomata can be counted.

Method 1

1. Put a small drop of water on a microscope slide.
2. Hold the leaf with the surface you want to examine uppermost.
3. Tear the leaf obliquely so as to reveal part of the epidermis.
4. Place the leaf on the microscope slide and examine.

Method 2

1. Paint the surface of the leaf with clear nail varnish.
2. Allow to dry.
3. Peel off the nail varnish with forceps.
4. Place on a dry microscope slide and examine.

Recording the distribution

The density of stomata on a leaf is recorded per unit area, usually the number per square mm.

A microscope is calibrated so that its field of view is known.

Calculating the area

In the illustration, the diameter of the field of view of the microscope is 0.40 mm.

Its area can be calculated using formula πr²

Where π:= 3.14 r = radius of the field of view

If the diameter of the field of view is 0.40 mm, the radius is 0.20 mm.

Area = πr² = 3.14 x 0.20 x 0.20 = 0.13 mm²

The number of stomata in the field of view is 12.

The area of the field of view is 0.13 mm²

Therefore, based on this single count, the density of stomata over 1 mm ² is:

The density of stomata is therefore 92 stomata per mm².